Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Warfbow?
#21
Looking good.
Reply
#22
(03-27-2019, 03:10 PM)ghost Wrote: Looking good.

Mailing it Friday.
Reply
#23
Warf51,

I'm assuming since ILF is a standard the riser limb pockets are all the same size. I don't seem to be able to google the dimensions however. I would like to measure the pockets on some of my compound bows to see if ILF limbs would fit. My daughter also has a PSE recurve with takedown limbs. I would like to see if I could get stronger limbs for her riser as well.

Could you tell me what the dimensions of the ILF limb pockets are?
Reply
#24
(03-27-2019, 08:14 PM)mac66 Wrote: Warf51,

I'm assuming since ILF is a standard the riser limb pockets are all the same size.  I don't seem to be able to google the dimensions however. I would like to measure the pockets on some of my compound bows to see if ILF limbs would fit.   My daughter also has a PSE recurve with takedown limbs. I would like to see if I could get stronger limbs for her riser as well.  

Could you tell me what the dimensions of the ILF limb pockets are?

0.437 wide at top. 0.250 deep. 45 angle.

(03-28-2019, 08:53 PM)Warf51 Wrote:
(03-27-2019, 08:14 PM)mac66 Wrote: Warf51,

I'm assuming since ILF is a standard the riser limb pockets are all the same size.  I don't seem to be able to google the dimensions however. I would like to measure the pockets on some of my compound bows to see if ILF limbs would fit.   My daughter also has a PSE recurve with takedown limbs. I would like to see if I could get stronger limbs for her riser as well.  

Could you tell me what the dimensions of the ILF limb pockets are?

0.437 wide at top. 0.250 deep. 45 angle.


Attached Files Thumbnail(s)
       
Reply
#25
Bottom width is 650 but not that important. The top entrance is held ot a standard of 0.437.
Reply
#26
(03-28-2019, 09:53 PM)Warf51 Wrote: Bottom width is 650 but not that important. The top entrance is held ot a standard of 0.437.

thanks for the specs.

I'm seeing that there are adapter plates available (at least for the Black Bear).
Reply
#27
(03-29-2019, 12:51 PM)mac66 Wrote:
(03-28-2019, 09:53 PM)Warf51 Wrote: Bottom width is 650 but not that important. The top entrance is held ot a standard of 0.437.

thanks for the specs.

I'm seeing that there are adapter plates available (at least for the Black Bear).

I cut em for about the same cost.
Reply
#28
https://youtu.be/A8wBmbl3W-4
Reply
#29
Warf51,

Can you convert a Bear Polar II
Reply
#30
You may have to get a hold of him on his website site.
Reply


Forum Jump:


Users browsing this thread: 1 Guest(s)