Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Magazine capacity
#1
Video 




Hard to get an exact round count, but I counted at least 10 rounds fired between the two times the primary engaged the target. That isn't counting other rounds by any of the other officers on scene. One reason why pistol capacity can be a very important consideration.  Although not every incident will require that many rounds, what if it does?  What if that knife-welding individual is on meth, benzos, spice, crack or cocaine? 

Tossing this out for consideration, debate, discussion.
Governmental dependance makes for poor self reliance.

"What could possibly go wrong with a duct tape boat?"  Cody Lundin

The best defense against evil men are good men with violent skill sets.
Reply


Messages In This Thread
Magazine capacity - by David - 07-11-2019, 08:58 PM
RE: Magazine capacity - by Ronin.45 - 07-12-2019, 02:55 AM
RE: Magazine capacity - by Ronin.45 - 07-12-2019, 05:28 AM
RE: Magazine capacity - by Tom Mac - 07-12-2019, 01:10 PM
RE: Magazine capacity - by David - 07-12-2019, 01:42 PM
RE: Magazine capacity - by bdcochran - 07-12-2019, 05:19 PM
RE: Magazine capacity - by Bob - 07-22-2019, 10:09 PM
RE: Magazine capacity - by bdcochran - 07-23-2019, 04:53 AM
RE: Magazine capacity - by Bob - 07-27-2019, 10:52 PM
RE: Magazine capacity - by Bob - 08-11-2019, 10:02 PM
RE: Magazine capacity - by Tom Mac - 08-12-2019, 11:29 AM
RE: Magazine capacity - by Bob - 08-17-2019, 07:18 PM
RE: Magazine capacity - by Tom Mac - 08-18-2019, 03:11 PM
RE: Magazine capacity - by bmyers - 08-12-2019, 12:36 PM
RE: Magazine capacity - by David - 08-12-2019, 12:57 PM
RE: Magazine capacity - by bmyers - 08-14-2019, 10:38 AM
RE: Magazine capacity - by Bob - 08-19-2019, 10:34 PM

Possibly Related Threads...
Thread Author Replies Views Last Post
  15 round magazine flush mount for G43x/G48 bmyers 3 126 09-16-2019, 11:10 AM
Last Post: bmyers
  Extended base plates for added capacity David 1 452 07-07-2018, 04:05 PM
Last Post: David

Forum Jump:


Users browsing this thread: 1 Guest(s)